Blue-ox SC9006 User Manual download pdf

Pender, Nebraska 68047 • Phone 402-385-3051 • Fax 402-385-3360 • www.blueox.com

Installation Instructions

1.Mount the two lights to the light brackets supplied as shown above. Using a ring

connector for each light, be sure to ground each of the white wires of the 6 wire

harness as shown above.

2.Then bolt the light brackets to the deck of the carrier with 1/4-20 x 3/4" or 1/4-20 x

2 1/2" carriage bolts, 1/4" flat washers and 1/4-20 hex nylock nuts depending on

what carrier you have.

3.Continue wiring the lights with the supplied butt connectors and 3/8" shrink

tube. Note: Be sure to slide shrink tube on wire before butt conncecting

wires together. The green wire connects to the red wire of the light on the

passenger's side. The yellow wire connects to the red wire of the light on

the driver's side. The brown wire of each light connects to the brown wire

of the 6 wire harness as shown above. After butt connecting all the

wires, use a heat shrink gun on all shrink tube.

4.Connect the 4 wire flat connector to the connection on the coach and

test the wiring to make sure everthing is operating correctly. If it is,

use the loom and wire ties to secure wires in place.

SC9005

Kit, Lights, Bolt On - Used on SC2000, SC2001, SC2100, & SC2101

292-2768 9/05 Page 1 of 1

If you should have any questions, please contact Blue Ox's Sales/Service Department.

1 2

Page 1

Page 2

No comments

Blue-ox SC9006 User Manual